SailNet Community banner
1 - 4 of 4 Posts

·
Registered
Joined
·
701 Posts
Discussion Starter · #1 ·
When new, my Lewmar XAS clutch opens and closes easily even unload. Now it takes some effort. I wanted to strip it to service. I unscrew the 3 bolts and nuts on the side but cannot split open the clutches. Any advise appreciated.
 

·
Telstar 28
Joined
·
992 Posts
Umm... Lewmar doesn't make the XAS clutch. Spinlock does. Be aware that Spinlock clutches often have a problem releasing if under a heavy load. That's one reason I don't like them and don't recommend them.
 

·
Hinterhoeller HR28
Joined
·
163 Posts
You can remove the cam in the Spinlock XAS without disassembly. Clean everything, and maybe a shot of McLube Sailkote on the lever pivot (NOT on the friction surfaces!)
 

·
Registered
Joined
·
701 Posts
Discussion Starter · #4 ·
Ok must be the sun that's clouding my sight, its Spinlock XAS. Thanks. I sparyed it with McLube, helped some but not to what I expect. Any idea how the cam can be removed without disassembly? Shouild I knock out the 1 large pin that holds all 3 cam lever ?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top