SailNet Community banner
1 - 2 of 2 Posts

· Telstar 28
Joined
·
43,281 Posts
Reaction score
297
Be aware, that most of those types of cable tie mounts fail after a short while, if under any tension. I would recommend using the weld-mount system or screw-mounted cable tie mounting points, rather than double-sided adhesive ones.
 

· Telstar 28
Joined
·
43,281 Posts
Reaction score
297
Good idea...lower maintenance than teak too. :)
I was going to use short pieces of PVC molding, 3/4" square as sold at Home Depot. Caulk in place where needed, then screw into it. Cheaper than teak, $5 for 8'.
Mike
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top