SailNet Community banner
1 - 4 of 4 Posts

· Registered
Joined
·
1,295 Posts
Reaction score
36
Discussion Starter · #1 ·
Hi All...

I need to secure the bilge pump hose so that it can not rub against the drive shaft. There is only one place the hose can enter the bilge, and if i leave it lose it will contact the shaft.

I am looking for something I can glue to the side of the bilge and then put a cable tie through. Any suggestions?

Thanks!
 

· Registered
Joined
·
1,295 Posts
Reaction score
36
Discussion Starter · #6 ·
I have not had success getting stick-on cable tie mounts to hold in our boats. I use screw or bolt types now. One option is to epoxy a piece of wood to the attachment point, and then screw a mount into that.
That would be my only option then, because if I put a screw in this spot it goes through the hull. But its not a bad idea. I was thinking of using 4000UV to secure these directly to the fiberglass in the bilge.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top