SailNet Community banner
1 - 2 of 2 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
After my Hood Seafurl 810 seized up, I loosened the sheave cover on the bottom to take a look and it seems to rotate fine now. Only problem is, I don't where the rope stripper, which popped out when I disassembled everying, goes. It seems to move around freely. Has anyone ever put one of these together? The diagram in the instruction manual doesn't really help in this regard.
 

·
Registered
Joined
·
4,192 Posts
The little rope stripper fits between the two halves of the drum/sheave. If you loosen the bolt that clamps the lower section on then just lower it a little, insert the stripper in the area between the openings, raise it up again and clamp it.
 
1 - 2 of 2 Posts
Top