SailNet Community banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hey all,
im here mostly to see if anyone can identify my new boat.(excuse my bike) Ive been sailing relationally all my life, but usually only on vacation every summer growing up. I used to have a force 5 that i rescued from certain death, but finances forced me to sell her after only two summers. Since ive been searching for something similar in size and came across this beauty for only a few hundred bucks, ready to sail, needing only cosmetic work, which i plan to do this winter. However, there are absolutely no tags on the hull, except for the number 888 on the stern, other than that all i know is that the mast is a Proctor. Any help would be greatly appreciated. Thanks!
 

Attachments

·
Registered
Joined
·
5 Posts
Discussion Starter · #6 · (Edited)
I will get a transom pic , and exact measurements asap ive been very busy with work and i keep leaving my tape at the job ( im a carpenter) It has an open transom, though the holes have been temporarily sealed up by the previous owner, they are just rubber flaps and the screws come right out and i plan to fix the holes that were drilled. as for the sails, they are replacements, made by North, the mainsail only has the number 6 on it. the spinnaker is tellow and blue and i believe is sporting the number 233 (ill have to pull it out to confirm that) ive had very little time to play with her yet, and have only had it on the water twice, but the does sail quite nicely. thanks for the leads ill check those out and see if anything matches my boat.
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #7 ·
mostly referencing images on google, so far none of the suggestions match. I know its not a mutineer, because i almost bought one a while back, it seemed bigger, and had a cool little cabin with a hatch i believe, more of a daysailer, this is definitely more of a racer.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top