SailNet Community banner

1 - 14 of 14 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
My Atomic 4 is not the most trustorthy and I have a 4HP Yamaha outboard ln my dinghy. In the case of an inboard engine failure I would like to have an emergency rig option to use the outboard as the main engine to propel my boat, a Tartan 34C.

Two possibilities I can think of is attaching the outboard to the transom high up and have a shaft extension that puts the propeller into the water. The other is to attach the outboard to the swim ladder and use some sort of tiller extension for steering.

Does anyone have experience with this or any good suggestions, keywords or links to photos or sites that describe examples?
 

·
Senior Member
Joined
·
19,489 Posts
I've seen various efforts at such a backup plan.. should work and other than the throttle you can steer with your own rudder for the most part.

After a a series of persistent fuel starvation issues a friend with a Hunter 37.5 just built a ladder mount out of 2x4s, essentially, that should do in a pinch - just in case.

If you can handle the aesthetics, I've seen a standard spring-loaded retractable OB bracket mounted as low as practical on the transom for just that eventuality. Also Chrisncate recently built a transom mounted bracket that you can slip an OB mount into.. see here:

http://www.sailnet.com/forums/general-discussion-sailing-related/82565-final-solution-what-i-came-up-regarding-auxiliary-propulsion-pic-heavy.html
 

·
Registered
Joined
·
132 Posts
Do you usually sail alone. If you have an extra hand, might be easier just to tie the dinghy up to the side of the boat and run it from there.
 

·
Registered
Joined
·
1,077 Posts
i have a transom mounted bracket that will pivot up so the outboard is out of the water when not in use,i lock the outboard down so it doesn't turn easily and use the main rudder,i like the reassurence of having it as a backup,i also keep about 5 gal. of gas for it.btw a six hp isn't going to do much for a boat your size especially in a strong current
 

·
Registered
Joined
·
1,077 Posts
even the most reliable engine can fail unexpectedly [murphys law] and ofcoarse it will be at the absolute worse possible time,its amazing how fast a 3-4 knot tide can push you toward a drawbridge etc
 

·
Daysailor wannabe cruiser
Joined
·
142 Posts
Just a thought

I considered something like this on my Cal 27 just in case because I carry a 6hp for my dinghy. However, if the engine fails then you can always sail.

In the event you can't sail because you are in a channel or something and trying to buck through chop and headwinds think about how you are going to reach down and lift that heavy thing down to the water, somehow contort your body enough to pull the cord the numerous times it would take and then adjusting throttle...etc all the while you are in chop or current.

If a current is pushing you towards rocks or a bridge, would you have time to even get it moving? And what is a 4 or 6hp really going to get you on the tartan 34? Maybe 3 kts or less with the outboard popping in and out of the water in the chop.

Maybe instead of taking the time and energy and money of mounting an outboard, you could put in a new carborator, water pump, starter, ignitinon, plugs, exhaust, fuel lines, dual filters, upgrade batteries, or whatever it is about the motor that keeps you up at night, and really get that motor back to reliable condition.

Just my .02.
 

·
Registered
Joined
·
4,304 Posts
If his A4 runs BUT is not reliable it can be repaired with a carb/fuel pump kit and decent electric connections to the motor as the motor is simpler than the average lawn tractor
 

·
Daysailor wannabe cruiser
Joined
·
142 Posts
I didn't mean that all of the things had to be done, but is there a certain problem that keeps you up at night or makes you cross your fingers when you turn the key?

On my boat which is smaller I really don't see myself hanging off the stern to pull the cord and shift to forward. An electric start motor might help though.

I realize the spirit of the question was how can I do this easily and cheaply and, trust me I've pondered the same thing.
 

·
Registered
Joined
·
62 Posts
Discussion Starter #10
Update: I did as suggested and learned about the A4 and replaced parts that were due for replacement and got plenty of spares. Then sailed her down to the Bahamas with some days motoring in the ICW and no problemo at all. Great engine!! My friends with their diesel who did this trip weren't that lucky...
 

·
Bombay Explorer 44
Joined
·
3,619 Posts
Another vote for the hip tow.

Try it out one day, you will be surprised how well even 4 hp can push 30 feet along.

But and it is a BIG BUT don't expect it to stop you in a hurry, reverse will not have much effect. Ask me how I know this.
 

·
Registered
Joined
·
86 Posts
I recently lost my forward gear (burnt/warped friction plates) while in the bahamas....luckily near spanish wells....reverse still works fine...after much thought...I was thinking about your idea but I only have a 2.5hp so that was out of the question...the problem was solved by ordering a reverse pitched prop (Left hand Instead of right hand) so now reverse is forward....hopefully getting me back to the states where a rebuild is not so expensive...the hip tie with the dink got me down the channel and to a dock where the props were switched out...I had my doubts of a 2.5 pushing 8000lbs of a 27ft sailboat...but it did the trick and now back on anchor waiting for weather to go home....
 
1 - 14 of 14 Posts
Top