SailNet Community banner
1 - 1 of 1 Posts

· Registered
Joined
·
68 Posts
Reaction score
10
Bill,
I have rewired both the bow and stern pulpits ON NiftyNickers.What you have is a great glob of 3m5200 it the hole in the deck thru which the wire passes.On the 37 the wire passes thru the rear-most port side leg of the bow pulpit.
You may be able to access the wire and glob by loosening that foot and raising it a couple of inches.The pulpit structure has enough GIVE to allow you to raise that foot a inch or so.
good luck,
Dianne and Chuck Burke S/V NiftyNickers C37 #139
+1. I had the same globs when I did the job on my Dana.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top