SailNet Community banner
1 - 1 of 1 Posts

· Registered
1 Posts
Reaction score
Discussion Starter · #1 ·
I'm just about to replace my sacrificial anodes. I need to replace the fixing bolts which go through the hull. Initial thought was that I could just use Sikaflex on the threads and bolt hole to ensure a watertight seal. Obviously the anode will be mechanically secured by the nuts on the inside of the hull. I have researched this and people say this is what to do. My question is :- Would it be safer to use epoxy to fix and seal the bolt where it goes through the hull or will the Sikaflex be enough?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.