SailNet Community banner
1 - 2 of 2 Posts

· One of None
Hunter 34
Joined
·
9,059 Posts
Reaction score
2,086
I think you will find standard 1/2"od ball end tubes fit the bottom nut of the "marine" facet. Basically they are the same as a bathroom facet's connection. Same on the Galley sink.




The "ball" end is basically the same as what would be a loose compression ring. The "nut" on the bottom of a facet is an oversize or reducing compression nut.
 

· One of None
Hunter 34
Joined
·
9,059 Posts
Reaction score
2,086
unless you are taking the sink out.. you will need one of these.. assuming you can even get under a head or galley sink.
 
  • Like
Reactions: SVAuspicious
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top