SailNet Community banner
1 - 2 of 2 Posts

· Read Only
Joined
·
87,689 Posts
Reaction score
825
Discussion Starter · #1 ·
I am installing new clutches to handle 5/16" halyards on a Frers 33. I am partial to the lewmar larger size, but they seem to rate safe working load lower than the spinlock XT model. Anyone out there have experience with either clutch??
 

· Read Only
Joined
·
87,689 Posts
Reaction score
825
Discussion Starter · #5 ·
I have Spinlocks XTs and have found them to work well. I Like the Idea with the Spinlocks that I can replace the cams for the smaller Hi Tec line without replacing the clutch. My experience with chafe problem is I end up replacing Halyards because of problems some else other then the clutches area .Antel also make a good clutch.
Bill S
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top