SailNet Community banner
1 - 2 of 2 Posts

·
Registered
Joined
·
256 Posts
Discussion Starter · #1 ·
Dear folks, I want to install a SCAD Solo Tank Monitor on our Holding tank. It looks like the forward face of the tank is just fiberglass (no plywood). Is that correct 'cause this monitor does not like working through plywood.

Many thanks and happy spring to all, Jay

PS 37,# 171, Kenlanu, Buck's Harbor, Maine
 

·
Registered
Joined
·
256 Posts
Discussion Starter · #3 ·
Thanks, Paul.
Does the poly holding tank on your boat (or others out there) have a plywood top held down with LOTS of screws like the two water tanks? Our holding tank has such a lid and I can see only fiberglass sides.

Jay, PS 37, # 171
 
1 - 2 of 2 Posts
Top