SailNet Community banner
1 - 1 of 1 Posts

· Registered
Joined
·
5,544 Posts
Reaction score
1,445
A couple years ago I redid all my dodger snaps and attachments. They were not bedded properly when initially installed. Drilled each hole out oversized, filled with epoxy, then drilled a pilot hole for the screw. Used a bit of chalk on each screw when reinstalled. All seem to be holding nicely.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top