SailNet Community banner
1 - 1 of 1 Posts

· Registered
Joined
·
712 Posts
Reaction score
171
Discussion Starter · #1 ·
Hi All,

With the refit of the mast systems complete, as I was restepping the mast, the cap shrouds went neatly into the spreader tips, installed a figure eight safety wire job and now that it's up, I'm not missing the big rubber boots that were previously installed, (much cleaner look). I have a 100% jib on now, and it doesn't come close to the spreader tips, BUT the 150 that's about to go back on will. My safety wire tails are curled and tucked neatly on the bottom of the spreader at the holes. I'm thinking about just taping over the end of the spreader (over the safety wire) and leaving the tip alone. Have any of you done "minimal" taping with success? Thoughts?

Dave
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top