SailNet Community banner
  • SailNet is a forum community dedicated to Sailing enthusiasts. Come join the discussion about sailing, modifications, classifieds, troubleshooting, repairs, reviews, maintenance, and more!

Spreader Issues

1816 Views 7 Replies 7 Participants Last post by  capta
Have an Endeavour 38 and noticed the port spreader sagging down one day. Well on investigation when we pulled the spreader off the socket/base it was discovered part of the base was broken. One of the previous owners at some stage had a problem with this and went in and drilled into the broken portion and ran a sheet metal screw in and then just wired the bushing in that the retainer pin goes through on the spreader. Looks like the tried to put some epoxy or JB Weld type material to fill it some. When the bushing broke up, that's why the spreader end on the mast dropped and the ends on the stays sagged some. Mickey mouse way of doing it and has been that way awhile. Guessing the PO did this just to get by and sell it. The bad part is the spreader base is welded to the mast. This is an Isomat mast. So wondering if there are any bright ideas out there. Guess at some stage going to have to have it pulled to work on. Any thoughts would be appreciated. Attached a pic if I did this right
Another Day
Daphne, AL



See less See more
1 - 1 of 8 Posts
Unfortunately this is very serious , and you have been very lucky not to have had the mast come down . That said, you IMO should higher a competent rigger . Good luck .
  • Like
Reactions: 1
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.