Joined
·
143 Posts
- Reaction score
- 3
Here is a link to a PDF copy of the manual
http://www.cncphotoalbum.com/atomic4manual/a4manual.htm
Is you engine raw water cooled or Fresh water cooled? The procedure is slightly differnet.
If fresh water cooled:
1. Close raw water thru-hull valve
2. Check oil
3. Check coolant in heat exchanger (1" or so below filler neck)
4. Run a hose from the raw water "T" valve into a bucket of fresh water
5. Check that the raw water "T" valve to the bucket is closed
6. start engine
7. check oil pressure
8. When the 5 gallon bucket empties (in about a minute) shut down the engine.
http://www.cncphotoalbum.com/atomic4manual/a4manual.htm
Is you engine raw water cooled or Fresh water cooled? The procedure is slightly differnet.
If fresh water cooled:
1. Close raw water thru-hull valve
2. Check oil
3. Check coolant in heat exchanger (1" or so below filler neck)
4. Run a hose from the raw water "T" valve into a bucket of fresh water
5. Check that the raw water "T" valve to the bucket is closed
6. start engine
7. check oil pressure
8. When the 5 gallon bucket empties (in about a minute) shut down the engine.
