SailNet Community banner
1 - 2 of 2 Posts

Super Moderator
Farr 11.6 (Farr 38)
10,616 Posts
The strut probably was a custom bronze casting. I don''t know of any Kirby 30''s that have had their engines pulled so here''s a couple suggestions.

Option 1
If you know of a Kirby 30 in your area see if you can borrow their strut and use it as a pattern and get a new one cast.

Option 2. Take careful measurements and have one welded up in stainless steel tube and plate. That may be the less expensive approach but mat prove to be a bigger pain in the butt over time.

Where is the boat?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.