SailNet Community banner
1 - 2 of 2 Posts

· ..........huh?..
Joined
·
395 Posts
Reaction score
40
Pub,

They do make an "easy out" of sorts that grabs the outside of the bolt head. Probably several brands, I know Craftsman has them. If you can't get something to grab then I kinda like bl's idea of grinding off the head, leaving you more to work with after removing the flywheel. Go carefully because if you break the darned bolt you WILL be drilling (and Probably tapping). Good luck, my Knuckles are bleeding in sympathy for you!

Doug
 

· ..........huh?..
Joined
·
395 Posts
Reaction score
40
Just a precautionary note if the welder option is viable. Ground as close as you can to your work, being careful not to ground on the other side of moving parts such as shafts and bearings. It is also a good idea to disconnect all power to protect your electronics.

Doug
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top