SailNet Community banner
1 - 4 of 4 Posts

· Registered
Corsair 24
Joined
·
4,590 Posts
Reaction score
1,360
I think you measured right bud...fwiw well actually edit I think you should measure the tube diameter at the highest point since you are looking at connecting id on the hose and od on the box...so take into account the barb

I dont see any isssues at ALL with warming the new hose up in water and soaping up both ends

I would try this first, it should be tight and it might end up working for you, before you go pss...

just a thought

is the lip or barb corroded? it might be bigger than new, so try removing as much scale and corrosion as possible and try...or is the pic you are showing of a new box? or cleaned up old one?

if still no go go 2 inch psss
 

· Registered
Corsair 24
Joined
·
4,590 Posts
Reaction score
1,360
I think this should be REALLY tight so warming and cussing , and using whatever methods to get it on should be tried

good luck!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top