SailNet Community banner
1 - 1 of 1 Posts

· Super Moderator
Joined
·
6,858 Posts
Reaction score
2,831
Unfortunately you will need an 1 7/8" hose. It is too bad builders went this route but back in the day they went with the cheapest vendors and often times the cheapest vendors used odd ball sizes.. You will need to try and source a 4 ply non-wire reinforced wet exhaust hose. I was able to find one a few years ago but can't remember where. If you can't find a 4 ply then you will need to use a 2 ply such as Shields #200. Call Trident and Shields and see what they have in 1 7/8" in a 4 ply no-wire hose....

T-Band clamps should not be used in bilge areas! The spot welds are prone to crevice corrosion and failure.... Use AWAB 316SS no-perforated clamps...
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top