SailNet Community banner
1 - 5 of 5 Posts

·
Registered
Joined
·
4,304 Posts
Discussion Starter · #1 ·
Well

After 28 years my mast is really needing some paint so i am glad i got and early start as it is really a lot of work removing all the hardware


The PO of the boat was a bit on the hack side so to no supprise many of the cam cleats were mounted with sheet metal screws

BUT in heating and PB blasting all the OEM 10-24 screws many did not make it and will have to be changed to 12-24 as the mast is to thin for heli-coils and some parts cant be moved

The big supprise in all this is every SS sheetmetal screw came out perfect :confused: go figure

The 3/16 SS rivets all drilled out perfect with no signs of hole dammage
 

·
Registered
Joined
·
4,304 Posts
Discussion Starter · #5 · (Edited)
I dont dont know of a place around here than can anodize a 35' section BUT i will look a bit and it is a bit on the wild side driving around with the 35' section on my trucks roof rack :eek: And i think it would be hard because they also sprayed the inside of the mast



The mast is kind of beat up and i feel paint will give the best looking end result IF i was buying a NEW mast it would be clear anodize for sure

I will be using perfection becasue it seems to have the best priming system and my friend did his at home last year at it has held up very good so far

1 . Vinal-Lux primewash
2. epxoy prime coat
3. perfection top coat

I also use to build and paint bicycles using the PPG version of Imron and own good SATA spraying EQU and saftey gear



I also have a indoor 60' room with a fume hood to draw the fumes out of the temp dust tent
 

·
Registered
Joined
·
4,304 Posts
Discussion Starter · #6 ·
I have been looking and the EPA seems to have chased all the anodizeing places to New Jersey :eek:
 

·
Registered
Joined
·
4,304 Posts
Discussion Starter · #8 ·
The rivets worked perfect and were easy to remove they will be replaced with new rivets

A few parts that used screws will be getting rivets BUT the parts that are to thick OR the sheeve retaining plates will have to stick with screws and will go to 12-24 with tef-gel as required
 

·
Registered
Joined
·
4,304 Posts
Discussion Starter · #11 ·
I was able to buy the Marson BIG DADDY for 85 dollars (normal about 150 dollars)

It will do stainless up to 1/4
 
1 - 5 of 5 Posts
Top