Joined
·
5,179 Posts
- Reaction score
- 662
I'd suggest:
1. Use a heat gun and scraper to remove the old paint/varnish
2. Sand back using a random orbital and 80 grit going to 120 grit if the surface is fair. If not, fair at will using your teak flour/epoxy mix.
3. At least one coat of two-pack CPES - note: this will cause any one-pack varnish you missed to bubble and flake off, in which case go back to 2 and repeat.
4. A light sand using 120grit followed by several coats of varnish (or paint) as you prefer.
As Christian points out: Don't glass it - bad idea.
1. Use a heat gun and scraper to remove the old paint/varnish
2. Sand back using a random orbital and 80 grit going to 120 grit if the surface is fair. If not, fair at will using your teak flour/epoxy mix.
3. At least one coat of two-pack CPES - note: this will cause any one-pack varnish you missed to bubble and flake off, in which case go back to 2 and repeat.
4. A light sand using 120grit followed by several coats of varnish (or paint) as you prefer.
As Christian points out: Don't glass it - bad idea.
